Hummer 12621662 Rail Assembly, Sequential Multiport Fuel Injection Fuel

You can Select Your Vehicle to check if 12621662 fits your vehicle.

First, remove the intake manifold cover to get it off the fuel injectors on a vehicle. It is also necessary to relieve the fuel system pressure and disconnect the negative battery terminal cable. After that, air intake and manifold cover bracket bolts are removed as well as the nut holding engine wiring harness bracket to intake manifold. Electrical leads in engine wiring harness traced and disconnected from various components including alternator, EVAP purge solenoid, ignition coils, MAP sensor and throttle body. Also, electrical connectors from fuel injectors were disconnected; engine wiring harness clips were detached too. The PCV hose is disconnected from the intake manifold while the fuel line is disconnected from the fuel rail. The EVAP canister purge solenoid is removed from the intake manifold while the fuel rail mounting bolts are removed. Thereafter, injectors are disengaged from engine as an assembly through lifting them out of top of intake manifold by each individual injector retainer with its old o-ring removed.New o-rings should be installed after which they are lubricated with clean engine oil before reassembling both injectors and fuel rail. This process however must be done in reverse starting by tightening up of fuel rail mounting bolts and then pressurizing of fuel system so as to ensure there are no leaks occurring during installation.

The accelerator and cruise control cables should be disconnected.

During the installation process, the fuel rail mounting bolts need to be tightened securely and the fuel system needs to be pressurized to check for leaks.

The air intake and manifold cover bracket bolts need to be removed, along with the nut securing the engine wiring harness bracket to the intake manifold.

The injectors are disengaged from the intake manifold as a single assembly.