Hummer 19210705 Pad Kit,Rear Disc Brake

You can Select Your Vehicle to check if 19210705 fits your vehicle.

To replace the brake pads on a vehicle, start by removing the covers from the brake fluid reservoir. Then, loosen the wheel lug nuts and raise the front or rear of the vehicle, supporting it securely on jackstands. Remove the wheels and work on one brake assembly at a time, using the assembled brake for reference if needed. Inspect the rotor carefully and remove it if machining is necessary, along with the pads from the calipers. Clean the brake with brake system cleaner and push the piston(s) back into its/their bore(s) using a C-clamp or flat bar. Be cautious of the fluid in the master cylinder rising and siphon off some if necessary. For installation, ensure to stay in order when replacing the disc brake pads on 2003 and later models. Tighten the caliper mounting bolts and wheel lug nuts to the proper torque specifications. Finally, depress the brake pedal a few times to bring the pads into contact with the disc and check the brake fluid level, adding more if needed.

If the rotor needs machining, carefully inspect it and remove it along with the pads from the calipers.

The initial steps to remove and replace brake pads on a vehicle are as follows:Loosen the lug nuts. Raise the vehicle on jackstands. Remove the wheels. Inspect the brake disc.

To complete the brake pad replacement, follow these steps: Install the caliper/bracket/brake pad assembly over the disc. Install the caliper mounting bracket bolts and tighten them to the torque specifications.

To replace the brake pads, follow these steps: Remove the outer brake pad. Separate the mounting bracket from the caliper. Remove the pad retainers from the bracket. Install new retainers. Remove the inner brake pad from the caliper.

The initial steps to remove and replace brake pads on a vehicle are as follows: Loosen the lug nuts. Raise the vehicle on jackstands. Remove the wheels. Inspect the brake disc.