GMC 15962181 Switch Assembly, Stop Lamp

You can Select Your Vehicle to check if 15962181 fits your vehicle.

Take away the brake light switch on models that were made in 1994 and beyond by unplugging the cable from the negative pole of the battery. Then, if necessary take off side knee bolster for a driver. After that undo the retainer holding brake switch and master cylinder push rod to brake pedal. Remove brake light switch and master cylinder push rod from brake pedal, also disconnect electrical connector from switch. Finally pull out the switch out of your automobile. Fit over a slave cylinder pushrod and secure to the pedal using a retaining clip as you install this type of machine on it first. Connect harness electrical connector into it. The rest installation steps are same as removal method but in reverse order. The self-adjusting nature of this kind of switch means there is no need for any adjustment . Check operation of brake lights after fitting,please .

To install the brake light switch, you should do the following: 1. Place the switch over the master cylinder pushrod. 2. Attach the switch to the brake pedal using the retaining clip. 3. Connect the harness electrical connector to the switch. 4. Complete the remaining installation steps in reverse order of removal.

The brake light switch is located on the brake pedal bracket and can be accessed by removing the trim panel beneath the steering column.