GMC 19329677 Pad Kit,Rear Disc Brake

You can Select Your Vehicle to check if 19329677 fits your vehicle.

To remove the brake assembly, start by removing the cap from the brake fluid reservoir and draining about two-thirds of the fluid. Then, loosen the lug nuts and raise the vehicle, supporting it securely on jackstands. Remove the wheels and inspect the brake disc, removing it if necessary. Clean the caliper, caliper bracket, and surrounding area before beginning the installation process. When reinstalling the caliper, ensure that the mounting bolts are tightened to the proper torque specifications, and do the same for the wheel lug nuts. After completing the job, depress the brake pedal a few times until it is firm, and check the brake fluid level, adding more if needed. Break in the new pads by making a few low-speed stops, allowing time for the discs to cool in between. Listen for any unusual noises and visually inspect the brake system for leaks or any components that may not have been properly reinstalled.

To remove the brake pads, loosen the lug nuts, remove the wheels, and inspect the brake disc. Depress the pistons into the caliper. Next, remove the caliper mounting bracket bolts and detach the caliper and brake pads from the steering knuckle, and hang the caliper. Remove the outer brake pad, separate the mounting bracket, and remove the pad retainers.

To remove the caliper and brake pads, follow these steps: Remove the caliper mounting bracket bolts. Detach the caliper and brake pads from the steering knuckle. Hang the caliper with a length of wire to prevent it from dangling and putting strain on the brake line.

To complete the brake pad replacement, follow these steps: Install the caliper/bracket/brake pad assembly over the disc. Install the caliper mounting bracket bolts and tighten them to the torque specifications.

To depress the caliper pistons, use a C-clamp to push them back into the caliper bores. This step creates enough space to fit the new, thicker brake pads onto the brake disc.

To complete the brake pad replacement, follow these steps: Install the caliper/bracket/brake pad assembly over the disc. Install the caliper mounting bracket bolts and tighten them to the torque specifications.

The initial steps to remove and replace brake pads on a vehicle are as follows: Loosen the lug nuts. Raise the vehicle on jackstands. Remove the wheels. Inspect the brake disc.

BOTH PARTS ARE DISCONTINUED AND THERE IS NO REPLACEMENT PART NUMBERS

part #19329677