GMC 25923437 Motor Assembly, Rear Window Wiper

You can Select Your Vehicle to check if 25923437 fits your vehicle.

Now remove the windshield wiper motor by prying off the windshield wiper trim caps and removing the retaining nuts and washers. Mark where each wiper arm is in relation to its shaft, then take them off. Next, remove the cowl cover and disconnect the electrical connector of the motor. Remove mounting bolts that secure a motor as well as linkage assembly to a cowl and then lift it out of that area. Pry linkage from a crank arm of a motor also removing an actuator arm from its shaft. Finally, remove mounting screws for motors together with motors themselves. To install, repeat all steps in reverse order while aligning marks made on an actuator arm, motor shafts as well as wiper arms or rather wiper arm shafts. For rear wiper motor, first get rid of trim cap and retaining nut situated at wipers' arms; mark position occupied by this rod concerning your engine's propeller; withdraw it. After removing liftgate trim panel and detaching electrical fitting of engine one must consequently do away with fasteners holding it up. In order to put back just do opposite actions still focusing on any marks left on washers that are mounted on arms along with their central parts on which these arms were fixed before removal too.

Reverse the removal steps and align the marks made on the wiper arm and motor shaft.

Remove the mounting bolts securing the motor and linkage assembly to the cowl, then lift it out of the area.

Reverse the removal steps and align the marks made on the actuator arm, motor shaft, wiper arms, and wiper arm shafts.