GMC 22756832 Front Wheel Bearing

To remove the rear wheel, start by loosening the lug nuts. Then, raise the rear of the vehicle and support it securely on jackstands. Remove the wheel and block the front wheels to prevent the vehicle from rolling off the stands. If you have an AWD model, remove the rear driveaxle/hub nut. Next, remove the brake disc and then detach the hub and bearing assembly from the knuckle by removing the bolts. If you have an AWD model, guide the driveaxle stub shaft out of the hub spines as you do this. If the shaft is stuck, you can use a rubber mallet, brass hammer, or a puller to remove it. To install the rear wheel, simply reverse the removal steps. Tighten the hub and bearing bolts to the specified torque and, for AWD models, tighten the driveaxle/hub nut to the suitable torque. Finally, install the wheel and lug nuts, lower the vehicle, and tighten the lug nuts to the specified torque.

To remove the driveaxle/hub, begin by loosening the driveaxle/hub and wheel lug nuts. Then, raise the vehicle and secure it on jackstands before removing the wheels. Remove the driveaxle/hub nut and the brake disc and use wire to support the driveaxle. Proceed to remove the hub and bearing assembly mounting bolts and then remove the hub and bearing unit. If the unit is stuck to the driveaxle, tap the driveaxle end with a hammer and a block of wood or use a puller to separate it from the knuckle, taking care not to damage the threads. For installation, simply reverse the removal steps and tighten the bolts to the specified torque.

After removing the mounting bolts, you should remove the hub and bearing unit.

After removing the brake disc, you should detach the hub and bearing assembly from the knuckle by removing the bolts.