GM 30006216 Steering Wheel(Gray)

You can Select Your Vehicle to check if 30006216 fits your vehicle.

To remove the Supplemental Inflatable Restraint (SIR) in a 1991 Metro, start by turning the ignition switch to the Off position. Then, remove the "SIR IG" fuse from the SIR fuse block. Next, take off the plastic access cover at the rear of the inflater module housing. Inside the housing, detach the yellow two-way connector and the position assurance connector. After that, detach the negative battery cable. Remove the four screws from the rear of the wheel and carefully remove the inflater module, making sure to keep the pad surface away from your face and body. When storing the module, always place the padded area up and avoid placing anything on or near it. To remove the steering wheel, remove the retaining nut and reference mark the position of the steering wheel-to-shaft. Use a steering wheel puller to carefully remove the wheel, taking care not to damage the SIR coil and turn signal/dimmer switch. Remove the horn switch screws and switches from the wheel, as well as the screws retaining the rear steering wheel cover. Reverse the removal procedure and use the reference marks made during removal to install the wheel. For all other vehicles, detach the negative cable from the battery and pull up on the steering wheel pad to remove it. Remove the nut retaining the steering wheel and reference mark its position to the shaft. Use a steering wheel puller to remove the wheel, and then reverse the removal procedure using the reference marks to install the wheel.