GM 15760691 Steering Wheel Assembly *Ebony

You can Select Your Vehicle to check if 15760691 fits your vehicle.

To remove the steering wheel, start by disconnecting both cables from the battery. If you have a 1994 model, simply pry off the horn cap. For airbag-equipped models, disable the airbag system first. On 1995 models, turn the steering wheel 90-degrees to access the holes in the backside of the steering wheel and use a thin hard tool to push in and release the four spring-loaded fasteners of the airbag module. On 1996 and later models, turn the steering wheel 90-degrees and insert a screwdriver into the holes to push aside the four spring clips and release the pins. Remove the horn contact plunger and contact plate, and unplug the yellow electrical connector on airbag-equipped models. Then, remove the steering wheel retaining nut and mark the position of the steering wheel to the shaft. Use a puller to detach the steering wheel from the shaft, avoiding hammering on the shaft. To install the wheel, align the marks on the steering wheel hub and shaft, slide the wheel onto the shaft, and tighten the nut to the specified torque. The rest of the installation is the reverse of the removal process.