GM 15289426 Switch Assembly, Turn Signal & Headlamp & Headlamp Dimmer & Windshield Wiper

You can Select Your Vehicle to check if 15289426 fits your vehicle.

If trying to replace the headlight switch in models of Impala ,first remove the left Instrument panel side cover and then with your fingers take out the headlight switch. Remove electrical connector by polarising this tab and pulling it off. For installation reverse all the process mentioned in the removal process until the switch and the bracket snap back into position. On Monte Carlo models pry off the headlight switch trim bezel, disconnect the electrical connector in the same way as previously, and remove the headlight switch from the front side of the trim bezel. Once more, installation works in the opposite of the removal process with emphasis on the fact that the switch is snapped into place. For the driver information display switch, take off the instrument cluster trim panel; by sliding some tabs lock and with the assistance of a clip push the switch from the front side of the panel. Slide forward the driver information display switch with finger for removal and for fixing reverse the steps that you have followed.

Remove the steering wheel along with the upper and lower steering column covers. Trace the electrical harnesses from the turn signal/multi-function switch down to the plastic strap that secures all the harnesses to the underside of the steering column, then remove the strap and disengage the ignition switch harnesses from the other harnesses. Detach the turn signal/multi-function switch by removing the two mounting screws, then disconnect the two electrical connectors and take out the switch. To disconnect the electrical connectors from the turn signal/multi-function switch, carefully pry the locking tabs loose and pull out the connectors. Installation is the reverse of removal.