GM 89047814 Rear Suspension Strut Kit

You can Select Your Vehicle to check if 89047814 fits your vehicle.

To remove the shock absorber, block the front wheels and loosen the lug nuts on the rear wheels. Raise the rear of the vehicle and support it securely on jackstands before removing the wheels. Remove the fasteners from the inner fender splash shield and move the liner out of the way to access the upper mounting bolts. Support the lower control arm with a floor jack and remove the shock absorber upper mounting bolts, discarding them as new ones will be needed during installation. Remove the shock absorber lower mounting bolt, also discarding it. Finally, remove the shock absorber.

For certain models, slide the steering knuckle into the strut flange and install the bolts and nuts, aligning the marks made during removal.

The damper rod should be extended, and the rubber bump stop and dust boot should be installed.

Check the strut for leaking fluid, dents, cracks, and other damage. Inspect the coil spring for chips or cracks in the coating, and the spring seat for cuts or deterioration. If any issues are found, proceed with the strut disassembly procedure.