GM 10455053 Motor Assembly, Start

You can Select Your Vehicle to check if 10455053 fits your vehicle.

If the starter motor cranks the engine at a slow speed, ensure that the battery is charged and all terminal connections are clean and tight. Additionally, check if the engine is partially seized or has the wrong viscosity oil, as these factors can also cause slow cranking.

The steps for removing the starter in a 2WD vehicle are as follows: Disconnect the negative battery cable. Raise the front of the vehicle and support it securely on jack stands. On V6 models, remove the right front wheel for easier access. Remove the front exhaust pipe from the exhaust manifold. On 2.2L engines, take off the brace rod from the front of the engine to the bell housing. On certain models through 1999, remove the support bracket connecting the front of the starter to the block. If equipped, remove the starter heat shield. From underneath the vehicle, disconnect the solenoid wire and battery cable from the terminals on the solenoid. Remove the starter mounting bolts. Take out the starter motor, noting the location of any spacer shim(s), if present.

To diagnose slow cranking, run the engine until it reaches normal operating temperature, then stop the engine, disconnect the coil wire from the distributor cap, and ground it on the engine. Connect a voltmeter positive lead to the starter motor terminal of the solenoid and the negative lead to the ground. Crank the engine and take voltmeter readings as soon as a steady figure is indicated, making sure not to let the starter motor turn for more than 15 seconds at a time. A reading of 9 volts or more, with the starter motor turning at normal cranking speed, is normal. If the reading is 9 volts or more but the cranking speed is slow, the motor is faulty. If the reading is less than 9 volts and the cranking speed is slow, the solenoid contacts are likely burned.

The steps for removing the starter in a 2WD vehicle are as follows: Disconnect the negative battery cable. Raise the front of the vehicle and support it securely on jack stands. On V6 models, remove the right front wheel for easier access. Remove the front exhaust pipe from the exhaust manifold. On 2.2L engines, take off the brace rod from the front of the engine to the bell housing. On certain models through 1999, remove the support bracket connecting the front of the starter to the block. If equipped, remove the starter heat shield. From underneath the vehicle, disconnect the solenoid wire and battery cable from the terminals on the solenoid. Remove the starter mounting bolts. Take out the starter motor, noting the location of any spacer shim(s), if present.