GM 22803619 Shaft, Rear Stabilizer

You can Select Your Vehicle to check if 22803619 fits your vehicle.

To remove the sway bar kit, begin by raising the rear of the vehicle and supporting it on jackstands. Then disconnect the sway bar kit links, using a Torx or Allen wrench if necessary to hold the ball stud in place. Unbolt the sway bar bushing retainers and remove the retainer brackets from the body if needed.

Start by loosening the front wheel lug nuts and raising the front of the vehicle on jack stands.

On 2007 and later models, lower the rear subframe enough to remove the stabilizer bar, although it is not necessary to remove the bar to replace the bushings.

Start by loosening the front wheel lug nuts and raising the front of the vehicle on jack stands. Remove the front wheels and detach the catalytic converter from the exhaust manifold on 2007 through 2009 models. Disconnect the stabilizer bar links from the bar, making sure to hold the ball stud with a Torx or Allen wrench if it turns with the nut. Disconnect the left tie-rod end from the steering knuckle and detach both stabilizer bar bushing retainers from the subframe. On 2007 through 2009 models, detach the steering gear from the subframe. Carefully remove the stabilizer bar from the left wheel well and inspect the retainer bushings for any cracks, wear, or deterioration. If necessary, replace them.