GM 22867701 Front Passenger Side Power Window Regulator And Motor Assembly (Rh)

You can Select Your Vehicle to check if 22867701 fits your vehicle.

To remove the window regulator assembly, start by removing the door trim panel and water shield. Then, remove the energy absorber and lower the window glass until the glass clamp fasteners are accessible through the access holes. Loosen the glass clamp fasteners without removing them and secure the window with tape. Disconnect the regulator motor electrical connector and remove the regulator fastener hole cover. Finally, remove the regulator assembly mounting fasteners and take out the window regulator assembly from the door. To install, simply reverse the removal steps and remember to lubricate the rollers and wear points on the regulator with white grease before installation.

To access the glass clamp fasteners, lower the window glass until they are accessible through the access holes.

During installation, the removal steps should be reversed, and it is important to lubricate the rollers and wear points on the regulator with white grease before installation.