GM 91174716 Motor & Bracket Asm,Wiper (On Esn)

You can Select Your Vehicle to check if 91174716 fits your vehicle.

First and foremost, first, you have to locate and remove the negative cable on the battery. After that, take off the cars' wrapper of the molded dash, and unscrew the dashboard upper mounting bolts, together with the lower mounting screws, to finally pull the dashboard back toward outside showing the dashboard mounting bolts. Then take out the screws in the mounting of dashboard and draw the dashboard back a little. Lift up the glove area and unveil the glove box mounting screws. It is advisable to scribe or paint the hood latch bolts for future use; now, the hood latch can now be removed and the cable disconnected from it. Pull the glove compartment with the hood latch cable out of the dashboard in an upward and then toward the rear and through the slot in the latch. The windshield wiper motor can be found beneath the dash on the passenger side close to the windshield; unscrew the two lower brackets through the glove box and the two overhead bolts at the dashboard. First, it is necessary to carefully take out the windshield wiper motor from the firewall, then to remove the nut connecting the wiper motor arm to the linkage, disconnect the electrical connectors, and, finally, to take out the motor through the glove box compartment. On sidekick x-90 vitara and tracker the windshield wiper motor is on the drivers side of engine compartment on firewall one should remove the electrical connector remove the two mounting bolts on the sides and just pull out the motor some what. Comstock the linkage nut, unfasten the windshield wiper motor and quickly pull the unit away from the engine compartment. Installation is just the opposite to removal for both vehicles.