GM 15253154 Rear Side Door Lock Assembly

You can Select Your Vehicle to check if 15253154 fits your vehicle.

Once in every three months or after every 3000 miles, some light oil or lock lubricant should be applied to the hinges for door, hood trunk, and latch assemblies. Also, a thin coat of grease is recommended to be spread on the door latch strikers to avoid too much wearing out and aid for an easy movement. Sprayed graphite lubricant is also applicable in doors and trunks locks.

To disengage the outside door handle lever from the handle reinforcement inside the door, pull it out of the door and to the rear. Inspect and replace the outside door handle seals if necessary. For the inside door handle, disconnect the actuator cable and reverse the removal procedure. For the door latch or outside door handle reinforcement, remove the outside door handle, reinforcement exterior retaining screw, and the latch mounting fasteners. Pull out the latch and rods from the door as a single assembly, disconnecting the rods and electrical connector if not done earlier. On a clean workbench, disconnect the outside handle and lock cylinder actuator rods from the latch or from the outside door handle reinforcement.