GM 90496706 Insulator,Rear Stabilizer Shaft

You can Select Your Vehicle to check if 90496706 fits your vehicle.

Loosen the rear wheel lug nuts. Check the front wheels to keep the vehicle from rolling, then raise the rear of the vehicle and support it securely on jackstands. Remove the rear wheels. Remove the hangers for the exhaust system, and the fuel tank heat shield by removing the fasteners securing it. Detach the left and right side sway bar link-to-trailing arm bolts. Unbolt the sway bar bushing clamp fasteners from the rear suspension crossmember, then remove the Sway Bar Kit. Pull the brackets off the Sway Bar Kit and inspect the bushings for cracks, hardness and other signs of deterioration. If the bushings are damaged, replace them. Installation is the reverse of removal, noting the following points: Lubricate the inside and outside of the new bushings with vegetable oil to simplify reassembly. Don't use petroleum or mineral-based lubricants or brake fluid-they will lead to deterioration of the bushings. These bushings are split so that you can install them without having to slide them onto the ends of the Sway Bar Kit. Install the bushings with the slit in each bushing facing towards the rear of the vehicle. Install the link bolts, insulators and nuts, tightening the bolts to the specific torque. Install the wheel and lug nuts, lower the vehicle and tighten the lug nuts to the specific torque.

Install the links and tighten the link nuts to the specified torque.

Loosen the front wheel lug nuts and raise the front of the vehicle. Support it securely on jackstands and remove the front wheels.