GM 12582219 Multiport Fuel Injector Assembly

You can Select Your Vehicle to check if 12582219 fits your vehicle.

To remove the fuel injectors, start by relieving the fuel system pressure and disconnecting the negative battery terminal. Then, remove the air intake duct and coolant overflow pipe if necessary. Release the quick-connect line fitting at the fuel rail and disconnect the electrical connectors from the fuel injectors. Remove the fuel rail mounting bolts and remove the fuel rail and injectors as a single assembly. Remove the retainer securing each fuel injector to the fuel rail and pull out the injector. Remove the old O-rings from each injector and discard them. For installation, lubricate the new injector O-rings with clean engine oil and tighten the fuel rail mounting bolts to the proper torque specifications. Reconnect the battery and start the engine to check for fuel leaks. On turbocharged engines, additional steps include removing the fuel rail high-pressure feed pipe and intake manifold. Carefully remove the foam fuel injector insulator, electrical connectors, and any remaining connections. Remove the fuel rail, using a special injector removal tool if necessary. Remove the old Teflon sealing ring and upper O-ring from each injector. To install the new Teflon seal, use the special tools included in the injector tool set or a socket of similar diameter. Install the support ring, upper O-ring, and Teflon seal on each injector. Clean the injector bores and install the spring steel retainer on each injector. Install the fuel rail and injectors, tightening the mounting bolts and high-pressure fuel line fittings to the correct torque specifications. Reconnect the battery and start the engine to check for fuel leaks.