GM 13591998 Rear Wheel Bearing

You can Select Your Vehicle to check if 13591998 fits your vehicle.

To remove the rear wheel, start by loosening the lug nuts. Then, raise the rear of the vehicle and support it securely on jackstands. Remove the rear wheels. Next, remove the brake shoes or disc brake assembly, and if applicable, detach the ABS wheel speed sensor electrical connector. Proceed to remove the hub bolts and detach the hub from the rear axle. Check the hub bearing for any signs of wear or damage, such as rough, loose, or noisy rotation. If any issues are found, replace the hub as an assembly since the bearing cannot be replaced separately. To install, clean the brake backing plate on both sides and the axle flange before installing the hub/bearing assembly. Tighten the hub and bearing assembly bolts to the specified torque. Finally, install the wheel and lug nuts, lower the vehicle, and tighten the lug nuts to the recommended torque.

To remove the hub/bearing assembly, start by loosening the driveaxle/hub nut and the wheel lug nuts. Then, raise the vehicle and support it securely on jackstands. Remove the wheel and the hub nut. Next, remove the brake disc and the ABS wheel speed sensor. After that, remove the three hub/bearing assembly mounting bolts from the inner side of the steering knuckle. Finally, remove the hub/bearing assembly from the steering knuckle and the end of the driveaxle, taking note of the orientation of the spacer. To install the hub/bearing assembly, reverse the removal steps, ensuring that the spacer is installed in its original manner. Lower the vehicle and tighten the lug nuts to the proper torque specifications. Lastly, tighten the driveaxle/hub nut to the proper torque specifications.