GM 22853824 Handle Assembly, Rear Side Door Inside *Jet Black

You can Select Your Vehicle to check if 22853824 fits your vehicle.

The Door Latch Assembly and window regulator module can be done away with through unplugging the electrical connector and removing the rods since they follow a modular design. For one, the bolt cover, just like the lock trim cover, can be removed to get rid of the outside handle; or a hooked tool can be used to keep the bellcrank lever at half open position during the handle's removal. To take out this lock, press and free it from its holding frame while separating its bar and stripping it off from the tie bar. The inside door handle is detached after taking off its panel by opening screws of materials that surround it using screws or other mechanical fasteners including nuts or bolts which are then disconnected from each other through disconnecting rods attached on metallic parts of their surfaces or ends.

The door lock cylinder can be removed by releasing the retaining clip and pushing the lock out of the handle frame, then detaching the rod and removing the lock.