GM 13529304 GENERATOR Assembly

You can Select Your Vehicle to check if 13529304 fits your vehicle.

Disconnect the cable from the negative battery terminal. Raise the vehicle and support it securely on jackstands. Remove the under-vehicle splash shield. Remove the drivebelt. For 3.2L V6 engines, remove the intake air duct mounting fasteners. Remove the alternator mounting fasteners and disconnect the alternator B+ terminal nut and electrical connector. Remove the alternator. For 2.8L, 3.0L, and 3.6L V6 engines (2007 and earlier models), install an engine support fixture or engine hoist. Disconnect the battery cable from the alternator and disconnect the electrical connector from the alternator. Disconnect the electrical connector to the Electronic Brake Control Module (EBCM) and remove the engine mount lower nuts. Remove the alternator lower mounting bolts and raise the engine enough to access the upper mounting bolt. Remove the upper mounting bolt and remove the alternator. For 2008 and later models, disconnect the battery cable from the alternator and disconnect the electrical connector from the alternator. Remove the alternator mounting bolts and remove the alternator. For V8 engines, remove the air filter housing and the radiator cooling fan. Remove the power steering pressure hose bracket fastener, if equipped. Remove the alternator mounting fasteners. Disconnect the battery cable from the alternator and disconnect the electrical connector from the alternator. Remove the alternator mounting bolts and remove the alternator. If replacing the alternator, ensure the new/rebuilt unit looks identical to the old alternator in terms of electrical terminals and identification numbers. Swap the pulley if necessary. Installation is the reverse of removal. Reconnect the cable to the negative terminal of the battery and check the charging voltage to verify the alternator is operating correctly.

When replacing an alternator, it is advisable that the charging system should be checked before removal or after removal, take it to a parts store or automotive electrical repair shop to check operation. Disconnect the negative battery terminal cable. Remove engine cover. Take off the air filter housing and intake duct for better access to the alternator. Remove drive belt. Lift up and support the front of car on jackstands. Remove under-vehicle splash shield. Under vehicle, disconnect electrical connectors from alternator. Disconnecting alternator electrical connector and removing nut and battery cable For a 1.5L engine, remove the alternator mounting bolts and nut, then remove the alternator from vehicle.Remove bolts and nut and remove alternator.If necessary for clearance, also remove stud. For 2.0L and 2.5L engines, remove lower alternator mounting bolt. Remove upper alternator mounting boll &nut from top of engine &remove alternator from vehicle…For all engines installation is reverse of removal..Tighten alternator bolts to specific torque. Check Charging system voltage to verify proper operation.