GM 91175475 End Kit,Steering Linkage Tie Rod Outer

You can Select Your Vehicle to check if 91175475 fits your vehicle.

To remove the tie-rod, start by loosening the wheel lug nuts and raising the front of the vehicle. Support it securely, block the rear wheels, and set the parking brake. Remove the front wheel. Then, loosen the jam nut enough to mark the position of the tie-rod end in relation to the threads. Remove the cotter pin and loosen the nut on the tie-rod end stud. Use a puller to disconnect the tie-rod from the steering knuckle arm. Remove the nut and separate the tie-rod. To install the tie-rod, thread the tie-rod end onto the marked position and insert the tie-rod stud into the steering knuckle arm. Tighten the jam nut securely. Install the castellated nut on the stud and tighten it. Install a new cotter pin. Finally, install the wheel and lug nuts, lower the vehicle, and tighten the lug nuts. It is recommended to have the alignment checked by a dealer service department or an alignment shop.