GM 15895556 Cylinder Kit,Front Side Door Lock (Uncoded)

You can Select Your Vehicle to check if 15895556 fits your vehicle.

Start by raising the window, then remove the door trim panel and water shield. On the outside of the door, remove the door handle cover carefully to avoid scratching the paint. Next, remove the door outer panel. Remove rivets, disconnect handle linkage, and remove the handle mechanism from the door. On the inside of the door, slide the door handle forward and unlatch the actuating rod from the door handle lever, then pull out and disconnect the front lock rod from the latch mechanism. Unhook the door handle actuating rods from the latch mechanism and remove the bolt from the lower section of the door jamb. Lower the window run channel, remove it from the door, and pull the upper weather strip to create space to raise the window glass. Disconnect electrical connectors from the latch mechanism, remove the latch mounting bolts, and angle the latch mechanism out of the door access hole. Remove the lock cylinder rod if not already removed, remove the clip, and take out the lock cylinder from the door. Installation is the reverse of removal, and it's advisable to replace the lock rod retainers when removed.

Start by raising the window and removing the door trim panel and water shield. Remove the door handle cover, door outer panel, rivets, and handle mechanism. Inside the door, slide the door handle forward and unlatch the actuating rod, then pull out and disconnect the front lock rod. Unhook the door handle actuating rod and remove the bolts from the window run channel. Remove the foam insulator, weatherstrip mounting screws, and pull the rear of the weather strip out. Disconnect electrical connectors from the latch mechanism, mark actuating rods for reinstallation, and remove them. Remove the latch mounting bolts, angle the latch mechanism out of the door access hole, and install it in reverse order, replacing lock rod retainers as needed.