GM 15866078 Headlamp Capsule Assembly

You can Select Your Vehicle to check if 15866078 fits your vehicle.

These models are equipped with composite headlights with adjustment screws for up-and-down movement, but left-and-right movement is not adjustable. To adjust the headlights, a blank wall 25 feet in front of the vehicle and a level floor are needed. Position masking tape on the wall in reference to the vehicle centerline and the centerlines of both headlights. Measure the height of the headlight reference marks from the ground and position a horizontal tape line on the wall at the same height. The adjustment should be made with the vehicle sitting level, the gas tank half-full, and no unusually heavy load in the vehicle. Turn on the low beams and use the adjusting screw to position the high intensity zone two inches below the horizontal line. For fog lights, some models have optional fog lights that can be aimed like headlights. There are no left-and-right adjustments for fog lights. Position tape on a wall 25 feet in front of the vehicle and tape a horizontal line representing the height of the fog lamp centers, as well as another line four inches below that. Use the adjusting screws on the fog lamps to adjust the pattern on the wall so that the top of the fog lamp beam meets the lower line.

The final step to remove the headlight housing is to take it out of the panel.