GM 92159965 Cylinder,Clutch Actuator

You can Select Your Vehicle to check if 92159965 fits your vehicle.

At the start of taking out the transmission, remove the quick-disconnect line bolt on the clutch slave cylinder for Aisin transmission models. On Tremec ones, undo the fitting at the tip of clutch line and withdraw it from clutch slave cylinder, blocking its end to prevent contamination. Remove clutch slave cylinder mounting bolts as well as clutch slave cylinder assembly if equipped with o-ring. To put back in place, start by putting new o-ring behind Aisin model's clutch slave cylinder. Tighten up the clutch slave cylinder into position until you hear a click for Aisin models. For Tremec types, cautiously screw in the clutch line fitting into the clutch slave cylinder with no thread damage. Install and tighten down bolts on clutch slave cylinders as per specified torque value. The bolt used to connect quick-disconnect of Aisin models' clutches shall be installed and torqued accordingly. Lastly, install transmission; check brake fluid level in reservoir while adding any necessary fluid; bleed system and again verify brake fluid in reservoir before starting engine.

yes except #24266013. correct #92159965 and no pilot bearing for this vin