Chevrolet 17804203 Transmission Asm,Auto (Goodwrench Remanufacture)(5Bcp)

You can Select Your Vehicle to check if 17804203 fits your vehicle.

Overhauling a manual transmission is a difficult job for the do-it-yourselfer, involving the disassembly and reassembly of many small parts. Numerous clearances must be precisely measured and, if necessary, changed with select fit spacers and snap-rings. If transmission problems arise, it can be removed and installed by a competent do-it-yourselfer, but overhaul should be left to a transmission repair shop. Rebuilt transmissions may be available -check with your dealer parts department and auto parts stores. The time and money involved in an overhaul is almost sure to exceed the cost of a rebuilt unit. However, it's not impossible for an inexperienced mechanic to rebuild a transmission if the special tools are available and the job is done in a deliberate step-by-step manner so nothing is overlooked. The tools necessary for an overhaul include internal and external snap-ring pliers, a bearing puller, a slide hammer, a set of pin punches, a dial indicator and possibly, a hydraulic press. A large, sturdy workbench and a vise or transmission stand will also be required. During disassembly of the transmission, make careful notes of how each piece comes off, where it fits in relation to other pieces and what holds it in place. This will make it much easier to get the transmission back together. Before taking the transmission apart for repair, it will help if you have some idea what area of the transmission is malfunctioning. Certain problems can be closely tied to specific areas in the transmission, which can make component examination and replacement easier.

Support the engine and transmission separately, with the latter supported by a special jack. Remove the nuts from the crossmember bolts, raise the transmission slightly, and remove the crossmember. On heavy-duty (cast iron case) transmission models, remove the transmission-to-clutch housing bolts; on normal-duty models, remove the transmission-to-engine bolts. Ensure all wires are disconnected, and then move the transmission and jack toward the rear of the vehicle until the transmission input shaft is clear of the clutch or clutch housing. Lower the transmission, taking care not to depress the clutch pedal while it's out.

To support the engine and transmission with jacks, you should use appropriate jacks to lift and secure both components. This is important for safe removal and reinstallation.