Chevrolet 8681909 Transmission Asm,Auto (Remanufactured)

You can Select Your Vehicle to check if 8681909 fits your vehicle.

After securing the transmission in place, you should reinstall the dipstick tube, starter motor, vacuum hose(s) (if equipped), shift and TV linkage or cable, wire harness connectors, torque converter cover, driveshaft(s), speedometer cable, and exhaust system components.

Support the engine and transmission separately, with the latter supported by a special jack. Remove the nuts from the crossmember bolts, raise the transmission slightly, and remove the crossmember. On heavy-duty (cast iron case) transmission models, remove the transmission-to-clutch housing bolts; on normal-duty models, remove the transmission-to-engine bolts. Ensure all wires are disconnected, and then move the transmission and jack toward the rear of the vehicle until the transmission input shaft is clear of the clutch or clutch housing. Lower the transmission, taking care not to depress the clutch pedal while it's out.

Overhauling a manual transmission involves the disassembly and reassembly of many small parts. Precise measurements of clearances must be taken and select fit spacers and snap-rings may need to be changed.

To ensure proper alignment of the torque converter during installation, turn the torque converter to align the marks on the converter and driveplate.

Yes, it is recommended to leave the overhaul of a manual transmission to a transmission repair shop.

Inspect the clutch components during removal. For installation, if the clutch components were removed, install them, and for heavy-duty four-speed models, attach the clutch housing if it was removed.