Chevrolet 10076709 Switch Assembly, Windshield Wiper & Windshield Washer

You can Select Your Vehicle to check if 10076709 fits your vehicle.

Detach the cable from the negative terminal of the battery, ensuring that on models equipped with the Delco Loe II audio system, the lockout feature is turned off before disconnecting the battery. Unplug the electrical connectors from the windshield wiper motor and washer pump, and detach the windshield washer fluid hoses from the pump. Disconnect the connector for the windshield washer fluid line at the wiper blade, then pop off the windshield wiper blade cap over the nut and remove the nut using a screwdriver. To remove the left windshield wiper blade assembly, use a small battery post puller or pry the blade off with a screwdriver, taking care not to damage it. Remove the four plastic pop fasteners from the left vent grille and take off the grille, being cautious as these fasteners can break easily. Next, remove the nut fastening the transmission linkage arm to the motor shaft and detach the linkage from the motor. Remove the motor mounting bolts, which consist of three bolts, and take out the motor. If replacing the motor, switch the washer pump to the new motor. For installation, follow the reverse order of removal. If only replacing the windshield washer pump, remove the small locking clip with a screwdriver and pull the pump from the bottom of the motor. To access the windshield wiper switch assembly, pop it loose from the dash with a small screwdriver and pull it out far enough to unplug the electrical connector, with installation following the reverse order of removal.