Chevrolet 19416896 STUD KIT,FRT LWR CONT ARM BALL

You can Select Your Vehicle to check if 19416896 fits your vehicle.

Use a large prybar to check for any movement in the balljoint by attempting to push it up and prying it down between the steering knuckle and control arm.

To inspect and potentially replace a ball joint, start by applying the parking brake and blocking the rear wheels to prevent the vehicle from rolling. Then, raise the front of the vehicle and securely support it on jack stands. Next, use a large prybar to check for any movement in the ball joint by attempting to push it up and prying it down between the steering knuckle and the control arm. Additionally, have an assistant grasp the tire at the top and bottom and move the top of the tire in and out while touching the ball joint stud nut. Finally, separate the control arm from the steering knuckle and try to twist the stud in the socket using your fingers.

To check the upper balljoint, loosen lug nuts, raise the front of the vehicle, support it on jackstands, apply the parking brake, and remove the wheel. Place a jack under the lower control arm, raise slightly, and watch for movement at the balljoint, indicating wear. For the lower balljoint, measure the distance between the tip of the balljoint stud and the grease fitting, lower the jack, and remeasure. A difference exceeding 3/32-inch means replacement is needed. To replace on 2WD models, remove the brake caliper, separate the balljoint from the steering knuckle, drill out the rivets, and install the new balljoint with supplied nuts and bolts. For lower balljoint, take the control arm to a shop for pressing out and in the balljoint. Inspect steering knuckle holes for damage, reconnect balljoints, tighten nuts to torque, install grease fittings, lubricate, and reinstall wheels. The alignment should be checked by a dealer. For 4WD models, procedures are similar, with additional steps including removing the splash shield, disconnecting the tie-rod, removing the drive axle, drilling out rivets, supporting the lower control arm, separating and installing the balljoint, and loading the torsion bar. Finally, reconnect tie-rod, install splash shield, and tighten lug nuts to specified torque.