Chevrolet 15201406 Speaker Assembly, Radio Rear Side Door

You can Select Your Vehicle to check if 15201406 fits your vehicle.

Remove the car radio by starting with removing the heater and air conditioning control assembly then the center trim panel. After that, take off four screws that hold radio in place and pull out the radio from dashboard while unhooking electrical connectors and antenna cables at rear side of the radio. To remove a door speaker, detach the door trim panel and unscrew speaker mounting screw before pulling it out of the socket and unplugging its wiring connection. When installing a speaker, ensure that lower mounting flange aligns with lower edge of speaker mounting hole in the door. Remove a tweeter by taking away its A-pillar trim panel and unplug tweeter electrical connector to it. Grasp tightly onto a tweeter grille to pull off both grille and tweeter as one unit, then carefully separate our small tool from three retainers which enables us to split tweeters apart from grilles using their large sizes. Reinstallation is just opposite to removal procedure for all components.

To remove a tweeter, start by removing the A-pillar trim panel. Once the trim panel is removed, disconnect the tweeter electrical connector. Then, firmly grasp the tweeter grille and pull off the grille and the tweeter as a single assembly. Carefully use a small screwdriver to disengage the three retainers and separate the tweeter from the grille.

To remove a door speaker, you first need to remove the door trim panel. Then, locate and remove the speaker mounting screw. After that, simply pull out the speaker and disconnect the electrical connector.

To remove the radio in a vehicle, you need to start by removing the center trim panel and the heater and air conditioning control assembly. Then, remove the four radio mounting screws and pull the radio out from the dash. Finally, disconnect the electrical connectors and antenna cable from the backside of the radio.

To remove the radio in a vehicle, you need to start by removing the center trim panel and the heater and air conditioning control assembly. Then, remove the four radio mounting screws and pull the radio out from the dash. Finally, disconnect the electrical connectors and antenna cable from the backside of the radio.

When installing a door speaker, make sure to align the lower mounting flange with and fit it inside the lower edge of the speaker mounting hole in the door. Secure the speaker in place by tightening the speaker mounting screw. Finally, connect the electrical connector to the speaker.