Chevrolet 26014287 Propeller SHAFT

You can Select Your Vehicle to check if 26014287 fits your vehicle.

First, remove the rear driveshaft by disconnecting the negative battery cable and then jack up the vehicle, securely supporting it on jackstands. To ensure proper reinstallation, put the transmission in Neutral with the parking brake off and make alignment marks on the driveshaft and differential flange. For two-piece driveshafts, tape the bearing caps to the spider and remove the bolts, nuts, and washers from the center support bearing bracket. Remove rear universal joint bolts and straps or companion flange bolts, nuts, and washers if a 4WD vehicle. For two piece drive shafts unbolt and take out nut from centre support bearing bracket and tape bearing caps into spider. Drop down back of propeller shaft to take it away from pinion flange; then slide front of propeller shaft out of transmission (or transfer case), or separate companion flange at transfer case (for 4WD vehicles). If transmission or transfer case end has a splined yoke, put a plastic bag over it to prevent fluid loss or contamination. On installation remove plastic bag wipe area clean and inspect oil seal. Slide front of propeller shaft into transmission (or transfer case) ensuring alignment marks are in place, or connect companion flange for same. Remove tape securing bearing caps install straps bolts and tighten as specified torque. Finally lower vehicle reconnect negative battery cable. In 4WD models' front driveshaft raise vehicle removing skid plate if applicable marking relationship of driveshaft to front differential flange as well as transfer case flange. Push rear half of driveshaft forward separating it from transfer case flange lower it then separate at differential flange. On installation attach front end of drive shaft to front differential flange installing straps and bolts finger-tight extending/compressing drive shaft as required attaching rear end to transfer case flange. Tighten all bolts to specified torque reinstall skid plate (if removed) lower vehicle, reconnect negative battery cable.

A driveshaft is a tube or pair of tubes that transmits power between the transmission or transfer case on 4WD models and the differential.