Chevrolet 15957475 Shaft,Rear Stabilizer

You can Select Your Vehicle to check if 15957475 fits your vehicle.

To uninstall the sway bar kit, you must first raise the rear of the vehicle and securely support it by using jack stands. Set up blocks on the front wheels to stop the car from rolling off its stands. Afterwards, remove the lower nuts, washers and bolts from sway bar kit-to-frame bracket links. Then remove U-bolt nuts and pull off the sway bar kit clamps. Finally, take out whole sway bar kit assembly. Also check for cracks, tears or deterioration in all sways bar kit and link bushings after removal to replace them if necessary. In short, undoing these steps should be followed with tightening of all fasteners up to torque specifications while installing a new sway bar kit.

Inspect the stabilizer bar and link bushings for any cracks, tears, or deterioration, and replace them if necessary.

When installing the rubber bushings on the stabilizer bar, you should ensure that they are positioned with the slits facing towards the front of the vehicle.

To reinstall the stabilizer bar, simply follow the reverse steps of removal and be sure to tighten all fasteners.

When installing the rubber bushings on the stabilizer bar, you should ensure that they are positioned with the slits facing towards the front of the vehicle.

Simply reverse the removal steps and make sure to tighten all fasteners to the proper torque.

After removing the nuts and link bolts, you should remove the rubber bushings and inspect all parts for wear and damage.