Chevrolet 12658478 Fuel Pump Assembly

You can Select Your Vehicle to check if 12658478 fits your vehicle.

To disassemble the fuel pump/fuel level sensor module, begin by removing it and placing it on a clean workbench surface. Disconnect the fuel level sensor connector at the top of the module and unplug the connector housing from the bottom of the fuel pump cover by disengaging the locking tab with a screwdriver.

To remove the high-pressure fuel pump, start by relieving the fuel system pressure and disconnecting the electrical connector. Then, disconnect the intake air ducting and remove the charge air cooler inlet pipe for better access. Loosen the fuel line fitting at the injector rail and the inlet/outlet lines at the high-pressure pump. Remove the bracket and fiber pump cover by removing the three bolts. Disconnect the flexible fuel line and remove the metal fuel lines from the high-pressure pump. Finally, remove the old fuel pump mounting bolts and discard them, replacing them with new ones. To install the pump, simply reverse the removal steps. Once everything is in place, start the engine and check for any fuel leaks.

If the fuel pump fuse, relay, and wiring are all okay, the fuel pump is likely defective.

To install the high-pressure fuel pump, you need to follow these steps: 1. Reverse the removal steps, starting with connecting the metal fuel lines to the high-pressure pump and reconnecting the flexible fuel line. 2. Attach the bracket and fiber pump cover by securing them with the three bolts. 3. Tighten the fuel line fitting at the injector rail and the inlet/outlet lines at the high-pressure pump. 4. Reconnect the intake air ducting and the charge air cooler inlet pipe. 5. Finally, start the engine and check for any fuel leaks.

Remove the fuel filler cap.

The pump-to-tank seal.

After the fuel pressure check, it is important to check for any fuel leaks.

Remove the fuel level sensor unit.

yes