Chevrolet 18026156 Pad Kit,Rear Disc Brake

You can Select Your Vehicle to check if 18026156 fits your vehicle.

To remove the brake pads, start by loosening the front wheel lug nuts and raising the front of the vehicle on jack stands. Remove the wheels and discard about two-thirds of the fluid from the master cylinder reservoir. Position a drain pan under the brake assembly and clean the caliper and surrounding area. Use a C-clamp to push the piston back into the bore, making sure the fluid in the master cylinder doesn't overflow. Inspect the caliper for leaks and damage, and also inspect the brake disc. Clean and check the caliper mounting bolts before tightening them to the proper torque specifications. To install the new brake pads, start by installing them on the opposite wheel, then install the wheels and lower the vehicle. Tighten the lug nuts to the specified torque. Add brake fluid to the reservoir and pump the brakes to seat the pads against the disc. Check the fluid level again and test the brakes before driving in traffic, avoiding heavy brake applications until the pads have been seated.

You can use a C-clamp to push the piston back into the bore, making sure the fluid in the master cylinder doesn't overflow.

Before installing the new brake pads, you should inspect the caliper for leaks and damage, and also inspect the brake disc. Clean and check the caliper mounting bolts before tightening them to the proper torque specifications.

Before installing the new brake pads, you should inspect the caliper for leaks and damage, and also inspect the brake disc. Clean and check the caliper mounting bolts before tightening them to the proper torque specifications.