Chevrolet 19332412 Fuel Tank Fuel Pump Module Kit

You can Select Your Vehicle to check if 19332412 fits your vehicle.

To remove the high-pressure fuel pump, start by relieving the fuel system pressure and disconnecting the electrical connector. Then, disconnect the intake air ducting and remove the charge air cooler inlet pipe for better access. Loosen the fuel line fitting at the injector rail and the inlet/outlet lines at the high-pressure pump. Remove the bracket and fiber pump cover by removing the three bolts. Disconnect the flexible fuel line and remove the metal fuel lines from the high-pressure pump. Finally, remove the old fuel pump mounting bolts and discard them, replacing them with new ones. To install the pump, simply reverse the removal steps. Once everything is in place, start the engine and check for any fuel leaks.

To remove the fuel pump/Fuel Level Sensor, start by disconnecting the cable from the negative battery terminal. Then, relieve the system fuel pressure and equalize tank pressure by removing the fuel filler cap. Next, remove the fuel tank and disconnect the fuel supply and return lines from the fuel pump/Fuel Level Sensor module, being careful to soak up any spilled fuel. Mark the orientation of the fuel pump in relation to the fuel tank for proper realignment during installation. Use water pump pliers to unscrew the locknut counterclockwise, or use a hammer and brass punch if it's tight. Remove the fuel pump/Fuel Level Sensor, taking care not to damage the fuel inlet strainer or the Fuel Level Sensor float arm and float. For installation, inspect and replace the pump-to-tank seal if necessary, and ensure the fuel pump inlet strainer is clean. Carefully align and insert the fuel pump/Fuel Level Sensor module into the tank, avoiding damage to the strainer, float arm, or float. Finally, reconnect the battery and allow the Powertrain Control Module (PCM) to relearn its former driveability and performance characteristics.

To disassemble the fuel pump/fuel level sensor module, begin by removing it and placing it on a clean workbench surface. Disconnect the fuel level sensor connector at the top of the module and unplug the connector housing from the bottom of the fuel pump cover by disengaging the locking tab with a screwdriver.

Depress the locking tab and slide it out of the slots on the module.

After the fuel pressure check, it is important to check for any fuel leaks.

After the fuel pressure check, it is important to check for any fuel leaks.