Chevrolet 15751173 Housing, Rear Brake Caliper (Lh)

You can Select Your Vehicle to check if 15751173 fits your vehicle.

To remove the brakes, start by loosening the lug nuts on the front or rear wheels and raising the vehicle securely on jackstands. Block the wheels at the opposite end for added safety. Remove the wheel and then proceed to remove the inlet fitting bolt and disconnect the brake hose from the caliper. Make sure to discard the old sealing washers and immediately plug the brake hose to prevent contaminants and air from entering the brake system. Next, remove the caliper mounting bolts and detach the caliper from the mounting bracket. In some cases, when removing a rear caliper, you may need to hold the slide pins with an open-end wrench to prevent them from turning. To install the brakes, simply reverse the removal process. Remember to use new sealing washers on each side of the brake hose inlet fitting and tighten the fitting bolt and caliper mounting bolts to the specified torque. Finally, bleed the brake system to ensure proper functionality.

Remove the wheel.