Chevrolet 22112745 Hose Assembly, Front Brake

You can Select Your Vehicle to check if 22112745 fits your vehicle.

Brake hoses are rubber covered flex hoses designed to transmit brake pressure from the metal tubes running along the frame to the calipers in front and wheel cylinders in the rear. To remove the hose, raise and support the vehicle, remove the through-bolt that fastens the hose to the caliper, remove any clips retaining the connection at the frame, and unscrew the flare fitting located on the pipe running along the frame. To install, replace the old hose with a new one, using new washers, then tighten the connection at the caliper, install any retaining clips or mounting brackets back into position, and lower the vehicle, then bleed the brake system.

Bend the pipe to match the old pipe allowing a clearance of at least 0.75 in. (19mm) from all moving parts and vibrations.

By hand or in a tubing bender, depending on the type of tubing used.

Copper tubing is prone to fatigue cracking and corrosion.

The hose should be replaced with a new one.