Chevrolet 96068685 Distributor

You can Select Your Vehicle to check if 96068685 fits your vehicle.

To remove the distributor, start by unplugging the distributor primary lead wire from the coil and disconnecting the electrical connector for the igniter. Locate the number one cylinder spark plug wire terminal by looking for a raised "1" on the distributor cap or tracing the wire back from the number one spark plug. Remove the distributor cap and position the rotor to point at the number one spark plug terminal. Make alignment marks on the distributor body, gear case, and distributor coupling (for 1996 models). Remove the distributor hold down bolt and clamp, then pull the distributor straight out. When installing the distributor, ensure it is inserted in the same position as before and mesh the helical gears by turning the rotor slightly. Check the alignment marks and rotor position, then place the hold down clamp and loosely install the bolt. Install the distributor cap, plug in the electrical connectors, reattach the spark plug wires, and connect the battery cable. Finally, check and adjust the ignition timing as needed.

After reassembling the distributor, the signal rotor air gap should be adjusted following the procedure.