Chevrolet 26028006 Boot Kit,Front Wheel Drive Shaft Cv Joint

You can Select Your Vehicle to check if 26028006 fits your vehicle.

CV boots are necessary because they function as a shield that prevents dirt, water, and debris from getting inside to destroy the constant velocity (CV) joints. Also, it is important to inspect them for tears, cracks, and loose clamps periodically. This can be done by tearing over time but regularly checking for tears, cracks and loose clamps on the boot on the pointed area if there any cracks or grease on it. In case of cracked covers or if the grease comes out through small opening then new boots have to be installed.

The driveaxle boots can be inspected by pushing on the boot and checking for cracks or leaking grease in the indicated area.

To install the CV joint assembly, you need to reverse the disassembly steps, ensuring the marks on the inner race and cage are visible after installation. Pack the CV joint assembly with grease and install the boot on the driveaxle. Position the CV joint assembly on the driveaxle and drive it onto the shaft until the retaining ring is seated. Finally, install the boot and retaining clamp, and secure the seal retainer.

The final step is to install the driveaxle.

After removing the inner CV joint, you should clean all the old grease from the housing and spider assembly, and inspect for any signs of wear. Then, pack the housing with grease and place the remainder in the boot. Slide the boot onto the axle and install the spider assembly with the recess facing the end of the driveaxle. Finally, install the tri-pot housing and adjust the collapsed dimension of the joint before installing the retaining clamps and the driveaxle.

After removing the outer CV joint, you should remove the old boot and mark the inner race and cage for reassembly. Remove the balls from the cage and remove the inner race from the cage. Clean all the components and inspect for wear.

Regular inspection of the driveaxle boots is necessary to check for signs of tears, cracks, and loose clamps.