Chevrolet 13464345 Boot Kit, Steering Gear

You can Select Your Vehicle to check if 13464345 fits your vehicle.

To remove the rack and pinion boot, start by loosening the lug nuts and raising the vehicle on jackstands. Remove the wheel and then proceed to remove the tie-rod end and jam nut. Use pliers to remove the outer boot clamp and cut off the inner boot clamp with diagonal cutters. Slide off the boot. Before installing the new boot, wrap the threads and serrations on the end of the steering rod with tape to protect the new boot. Slide the new boot into position on the rack and pinion, making sure it seats in the groove on the steering rod, and install new clamps. Remove the tape and then install the tie-rod end. For installation, start by installing the wheel and lug nuts, then lower the vehicle and tighten the lug nuts to the proper torque specifications. Finally, have the front-end alignment checked and adjusted if necessary.