Chevrolet 15184702 Blade,Windshield Wiper

You can Select Your Vehicle to check if 15184702 fits your vehicle.

Inspect the windshield wiper and blade assembly regularly for damage, loose parts, and worn blades. Clean blades with mild detergent to remove road film. Check and tighten bolts, nuts, and fasteners during blade checks. Replace cracked or worn blades. Some models have press-type release levers to remove old blades. Install new blades by pressing them onto the wiper arm pin until they snap into place. The blade element is secured by a spring-loaded retainer and metal tabs. To remove, slide the blade under the element near the tabs and slide it up. To install, align the slot in the element with the tabs and snap it into place.

Two methods retain the wiper blade element. One uses a red press-button; press it to slide the element off and push the new one until it locks. The other has a spring-type clip at the element's end. Pinch the retainer to slide the element out. Use pliers if needed. Ensure the metal insert goes through the blade assembly's tabs when installing a new element.

The action of the wiping mechanism can loosen the bolts, nuts, and fasteners.

The bolts, nuts, and fasteners should be checked and tightened, as necessary, at the same time the wiper blades are checked.

To reinstall the wiper arm/blade assembly, you simply need to reverse the removal process. Make sure that the connector is fully pushed onto the arm and that the small locating 'pip' securely fits into the hole in the connector.

Start by disconnecting the negative battery cable and removing the instrument cluster trim panel. Then, remove the switch from the rear by taking out the 2 mounting screws.

In the other type of windshield wiper assembly, the blades park in a depressed position against a step on the windshield lower molding.