Chevrolet 10313647 Front Shock Absorber Assembly

You can Select Your Vehicle to check if 10313647 fits your vehicle.

To dismantle the shock absorber it is necessary to, - Relax the wheel lug nuts - Lift the car and put it on the jackstands - Take off the wheel For models equipped with the electronic ride control deenergizes the shock absorber electrical connector on top of the unit. Models with Electronic Suspension Control have to be taken with care since the upper shock shaft can be damaged and the shocks have to be replaced. Place the lower control arm on the floor jack to some extent to provide room for the removal of lower mounting nuts. Subsequently, disconnect the upper retaining nut accompanied by the washer and the bushing from the shock in the process as summarized below; Remove the lower nuts and bolts that attached this shock to the lower control arm. For 2008 and earlier models with FE3 or F55 suspension, find a prybar and to compress the shock from the bottom and hold this shock in place. On 2009 models and later, it is necessary to unlock the bolts that attach the upper control arm to the frame and place markings for the shims before turning the upper control arm for shock removal. After the removal of the shock, check for signs of shake such as, any fluid leakage, dents, crackages or bushing which might have degraded and needs to be replaced. For installation, insert the top most section of the shock through the upper threaded hole in the lower control arm while still compressed if the car employs FE3 or F55 suspension then push down at the lower control arm until the respective holes align before springing it back to normal use. For all other models, the shock must be fitted with the upper eyelet first and tight the fasteners up to the recommended torque value. The remaining installation steps are in the reverse order of removal and for 2009 and later models make sure the shims are aligned correctly if the shims we reinstalled.

Check the tires for irregular wear patterns and proper inflation.

The lower control arm should be supported with a floor jack.

This part number is just 1 front shock

No, these shocks are not adjustable at all

The shocks will seem like they lifted the vehicle until the weight factor comes into play and settles the amount of ride height by compressing the shock