Chevrolet 19368454 ABSORBER ASM,FRT SHK

To remove the model of a coil-over shock absorber, start by loosening the front wheel nuts which hold together its lug, lift up the automobile and remove it tire. Use a floor jack to support the external end of lower control arm and detach the tie-rod end from steering knuckle. Remove top mounting nuts and two bolts that attach bottom of shock absorber to lower control arm. Pull it out from below. To install, reverse removal steps for installing new shocks and tighten fasteners as per their torque specifications. If equipped with a suspension control system, reconnect electrical plug at top of shock absorber. For torsion bar models, follow same steps but back up wrench on stem is used for removing upper mount nut as well as related hardware. Observe direction in which bolt points while removing the lower mounting nut and bolt. Reverse removal steps when installing making sure that lower mounting bolt is pointing exactly in the same spot it did before.

If the vehicle is equipped with a ride control system, the electrical connector and the airline should be disconnected from the shock absorber.

To install, reverse the removal steps and ensure the lower mounting bolt is pointing in the same direction as before.

Inspect the shocks to ensure they are securely mounted and undamaged. Check the upper mounts for damage and wear.

Follow the same steps as removing the coil-over shock absorber model, but use a backup wrench on the stem to remove the upper mounting nut and related hardware. Remove the lower mounting nut and bolt, noting the direction in which the bolt points.

The shock absorber can be installed by reversing the removal steps and tightening the fasteners to the torque specifications.

Start by loosening the front wheel lug nuts, raising the vehicle, and removing the wheel.

The front wheels should be blocked to prevent the vehicle from rolling off the stands.

Have an assistant grasp the lower edge of the tire and move the wheel in and out while you look for movement at the steering knuckle-to-control arm balljoint. If there is any movement, the suspension balljoint(s) must be replaced.

To install, reverse the removal steps and ensure the lower mounting bolt is pointing in the same direction as before.

Grasp each front tire at the front and rear edges, push in at the front, pull out at the rear, and feel for play in the steering system components. If any free play is noted, check the idler arm and the tie-rod ends for looseness.

Grasp each front tire at the front and rear edges, push in at the front, pull out at the rear, and feel for play in the steering system components. If any free play is noted, check the idler arm and the tie-rod ends for looseness.

If the vehicle is equipped with a ride control system, the electrical connector and the airline should be disconnected from the shock absorber.

Driveaxle boots are important because they prevent dirt, water, and foreign material from entering and damaging the constant velocity (CV) joints. Inspect the boots for tears, cracks, as well as loose clamps.

Have an assistant grasp the lower edge of the tire and move the wheel in and out while you look for movement at the steering knuckle-to-control arm balljoint. If there is any movement, the suspension balljoint(s) must be replaced.

The front wheels should be blocked to prevent the vehicle from rolling off the stands.

The first step is to raise the rear of the vehicle and support it securely on jackstands placed underneath the frame rails.

Start by loosening the front wheel lug nuts, raising the vehicle, and removing the wheel. Support the outer end of the lower control arm with a floor jack and detach the tie-rod end from the steering knuckle. Remove the upper mounting nuts and the two bolts that attach the lower end of the shock absorber to the lower control arm. Pull the shock out from below.

Per your VIN, that part number is not applicable to your vehicle. The description on the part # is Absorber, shock. It does not include any additional parts.

p # not needed is 19353951 for left and right. the spring would be sold separate. p # 20842473 for left and right