Cadillac 15759723 Steering Wheel Assembly *Graphite

You can Select Your Vehicle to check if 15759723 fits your vehicle.

To remove the steering wheel, start by disconnecting both cables from the battery. If you have a 1994 model, simply pry off the horn cap. For airbag-equipped models, disable the airbag system first. On 1995 models, turn the steering wheel 90-degrees to access the holes in the backside of the steering wheel and use a thin hard tool to push in and release the four spring-loaded fasteners of the airbag module. On 1996 and later models, turn the steering wheel 90-degrees and insert a screwdriver into the holes to push aside the four spring clips and release the pins. Remove the horn contact plunger and contact plate, and unplug the yellow electrical connector on airbag-equipped models. Then, remove the steering wheel retaining nut and mark the position of the steering wheel to the shaft. Use a puller to detach the steering wheel from the shaft, avoiding hammering on the shaft. To install the wheel, align the marks on the steering wheel hub and shaft, slide the wheel onto the shaft, and tighten the nut to the specified torque. The rest of the installation is the reverse of the removal process.

Turn the steering wheel 90-degrees to access the holes in the backside of the steering wheel and use a thin hard tool to push in and release the four spring-loaded fasteners of the airbag module.

Turn the steering wheel 90-degrees, insert a screwdriver into the hole for each of the four spring clips, and push the spring aside to release the pin.

Unplug the yellow electrical connector from the module and set the module aside, with the airbag side facing UP.

Simply pry off the horn cap.

The rest of the installation is the reverse of the removal process.

4 16759294 DISCON WHEEL, STRG (GRAPHITE)(W/AIR BAGS) - IS THE CORRECT PART PER VIN.