Cadillac 12602113 Rail Assembly, Multiport Fuel Injection Fuel

You can Select Your Vehicle to check if 12602113 fits your vehicle.

First, remove the intake manifold cover to get it off the fuel injectors on a vehicle. It is also necessary to relieve the fuel system pressure and disconnect the negative battery terminal cable. After that, air intake and manifold cover bracket bolts are removed as well as the nut holding engine wiring harness bracket to intake manifold. Electrical leads in engine wiring harness traced and disconnected from various components including alternator, EVAP purge solenoid, ignition coils, MAP sensor and throttle body. Also, electrical connectors from fuel injectors were disconnected; engine wiring harness clips were detached too. The PCV hose is disconnected from the intake manifold while the fuel line is disconnected from the fuel rail. The EVAP canister purge solenoid is removed from the intake manifold while the fuel rail mounting bolts are removed. Thereafter, injectors are disengaged from engine as an assembly through lifting them out of top of intake manifold by each individual injector retainer with its old o-ring removed.New o-rings should be installed after which they are lubricated with clean engine oil before reassembling both injectors and fuel rail. This process however must be done in reverse starting by tightening up of fuel rail mounting bolts and then pressurizing of fuel system so as to ensure there are no leaks occurring during installation.

Any wiring harnesses that may interfere with fuel rail removal should be disconnected.

The EVAP canister purge solenoid needs to be removed from the intake manifold.