Cadillac 19208471 Piston Kit,Engine

You can Select Your Vehicle to check if 19208471 fits your vehicle.

When removing piston/connecting rod assemblies, start by checking for ridges at the upper limit of ring travel in each cylinder and remove them if present to avoid piston breakage. For verifying connecting rod endplay with feeler gauges, make sure that it does not exceed the service limit. The connecting rods and caps must be carefully labeled for proper reassembly. After removing the bearing insert, remove connecting rod cap fasteners and push the connecting rod/piston assembly out of the engine. To protect them, place the removed heads on blocks of wood. While installing piston rings, check and adjust ring end gaps so they are within specified limits and install rings correctly on each piston. Lubricate pistons, rings and cylinders with engine oil during installation and use a piston ring compressor. Make sure cylinder walls are clean when installing piston/connecting rod assemblies; apply engine oil to them; then guide each assembly into a cylinder being careful about its orientation. Verify connecting rod bearing oil clearance using Plastigage to ensure it meets specifications Apply grease or assembly lube to bearing faces before final installation of rod caps and bolts Repeat these steps for all piston/connecting rod assemblies; then rotate the crankshaft by hand checking for binding Finally, check correct connecting rod endplay, take rods for resizing if new components were installed.

After installing all piston/connecting rod assemblies, you should rotate the crankshaft by hand to check for any binding. It is also important to check the connecting rod endplay for correctness. If necessary, the rods may need to be taken for resizing if new components were installed.

During piston ring installation, you should check and adjust the ring end gaps to ensure they are within specified limits. The rings should be installed correctly on each piston. It is important to lubricate the pistons, rings, and cylinders with engine oil during installation. Additionally, a piston ring compressor should be used.