Cadillac 94708774 Lamp,Front Fog

You can Select Your Vehicle to check if 94708774 fits your vehicle.

These models are endowed with fiberglass headlamp assemblies with up and down movement adjustment screws, which are 6 mm hexagonal and right and left are fixed. On seating the procedure for adjusting the headlights requires one to ensure that there is a blank wall that is placed at 25 feet from the vehicle on a level ground. Place a masking tape on the wall so that it corresponds with the position of the centerline of the vehicle, the centerline of both headlights should also be placed on the tape. Stand back from the car and ensure the height of the marks on the headlight is same of that on the chassis then transfer a horizontal line on the wall at the same height. If possible, it is better to position the car just a few inches away to facilitate taping of the tape to the Bureau. It is recommended that the vehicle should be as level, with the fuel tank half full and without any heavy load during the adjustment. When low beams are in effect, turn the adjusting screw up or down to establish that the high intensity zone nine inches below the marked horizontal. For proper adjustment one should turn to a qualified independent repair shop or dealer service department for headlight examination. There are also models with parking lights that can be also swivelled similar to headlights, though adjustment at left-and-right is not usually possible. To adjust fog lights, one has to put a tape on a wall, the distance of which should be 25 feet away from the car with two horizontal lines on it: the upper one marking the level of the fogg light axes and the lower one - four inches beneath. Lose the adjustment screw for each fog light by looking through the grille above the light and rotate the screw until the upper edge of the fog light beam is parallel with the lower edge of the wall line.