Cadillac 25769586 Transmission Fluid Cooler Lower Hose Assembly

You can Select Your Vehicle to check if 25769586 fits your vehicle.

The automatic transaxle fluid is assembled with an auxiliary oil cooler in certain early models. In appearance, this cooler resembles a small radiator and is located at the front of the engine radiator and air conditioning condenser behind the grille. The transaxle fluid's passage is from the transaxle via the transaxle fluid output line to an additional cooler which directly flows into a standard cooler located inside the right-hand tank of the radiator. Place a drain pan under it for any leaking fluid; then separate it by taking off the lower fluid line. Remove upper fluid line only when there are no more droplets of oil dropping down from it. To take away this part, remove the screws that attach on top of the radiator support structure and also detach lower support bracket. Conversely, fix it back in place just as you removed it. Incase of ease in access to lower cooler line at front side of transaxle, remove air filter housing if necessary. In order to catch any liquid that may start to leak out from them, you should put a drain pan under these lines prior to removing them. Unlock plastic collar by unsnapping quick-connect fitting after which quickly pull out clip so as to remove lines completely. Loosen two bolts securing upper cooler line brackets to transaxle afterwards removing those sections entirely from vehicle body's system. Pull out rear connector linking upper transmission cooling pipe with its base unit in consideration of coming away with it first. Disconnect one end of lower cooling pipe among intermediate pieces and finally separate all joints easily while standing on up-down position respectively . The remaining steps during reassembly are shown below: Ensure that all fasteners and fittings are securely tightened. On later models equipped with quick-connects, push upper cooling tube into fitting until click is heard or felt in fingers; afterwards slightly tug on tubing so as to confirm tightness before sliding protective sleeve over connection point itself . Verify your transmission fluids.