Cadillac 25732181 Transmission Shifter Cable Assembly

You can Select Your Vehicle to check if 25732181 fits your vehicle.

There is a process involved in floor shift models. This should be performed by positioning the shift lever in neutral. The process then involves opening the engine compartment and disconnecting the transaxle shift cable from the shift lever. In order to do this, the clip on holder, U-clip retainer has to be removed then squeezing tangs on the cable housing before it comes out of its bracket. In addition, remove the clip from the cable and then undo shift lever assembly where grommet is pried off that pulls out shift cable through hole in mount at front side (of course). Therefore, this might require pulling back carpeting if necessary just so that you can access this thing. We need to take off this with flat-bladed screwdriver so as not to damage any other components around it!" Remove it from your car after taking out its inner part by removing grommet that connects it to firewall or elsewhere. Installation process will involve guiding new cable via hole located on floor as well as secure it using grommet together with connecting onto shifter also adjusting based upon ones desire. Column-shift models begin similarly in engine compartment with disconnection of a shifting rod case from transaxle level plus removing a U-clip retainer for its release from bracket. This leaves us only with low sound insulator panel located under dash thereby enabling us easily reach there and disconnect end of cables from gearshift control lever which is one more step in our procedures. To remove this, all you have to do is release clamp and pull up on tangs when need arises where after lifting lock on topmost layer will require them pushing further ahead until they come out completely." Having pulled it out, we can now reinstall everything beginning with reverse side of firewall as per granular installation processes detailed above; finally tightening fasteners as much possible without damaging anything else." One can lift button tab using screwdriver thus adjusting lock fingers shall also open as soon as they are released or when transaxle lever stands at neutral position then the direction of movement changes into park before putting lock tab which is found beneath this assembly that incorporates cable grommet.