Cadillac 19300488 Balancer Asm,Crankshaft

You can Select Your Vehicle to check if 19300488 fits your vehicle.

Disconnect the cable from the negative terminal of the battery. Remove the engine cooling fan, then remove the engine drivebelt. Remove the bolts and separate the crankshaft pulley from the harmonic balancer. Remove the large harmonic balancer-to-crankshaft bolt. To keep the crankshaft from turning, remove the starter and have an assistant wedge a large screwdriver against the ring gear teeth. A chain or strap wrench can also be used to secure the balancer. Using the proper puller, detach the harmonic balancer from the crankshaft. Be careful not to lose the Woodruff key. Make a written note of any weights used in the balancer, their locations, and lengths. These weights must be installed in exactly the same way when the balancer is installed. If a new harmonic balancer is being installed, transfer the weight(s) to the new balancer in the proper location(s). Make sure the woodruff key is in place, then position the harmonic balancer on the crankshaft and slide it on as far as it will go. Use a small dab of RTV sealant on the keyway of the balancer before installation. Note that the slot (keyway) in the hub must be aligned with the Woodruff key at the end of the crankshaft. Using a harmonic balancer installation tool, press the balancer onto the crankshaft. Note that the crankshaft bolt can also be used to press the crankshaft balancer into position, but when doing so, use a liberal amount of clean engine oil on the bolt threads to prevent galling. Make sure the raised crown of the balancer bolt washer is away from the crankshaft. Tighten the crankshaft bolt to the torque specifications. The remainder of installation is the reverse of removal.

Disconnect the cable from the negative terminal of the battery. Raise the front of the vehicle and support it securely on jackstands, then apply the parking brake. Remove the drivebelt, cooling fan, and shroud assembly. Working under the vehicle, remove the stone shield from below the engine if equipped. Remove the starter motor. Have an assistant wedge a large screwdriver or prybar into the driveplate ring gear teeth, then loosen the harmonic balancer pulley center bolt. Pull the balancer off the crankshaft with a puller. Position the harmonic balancer pulley/balancer on the crankshaft and slide it on as far as it will go. Using the harmonic balancer installation tool, press the harmonic balancer pulley/balancer onto the crankshaft. Install the old harmonic balancer bolt and tighten the crankshaft bolt to the proper torque specifications. Remove the old bolt and measure the distance from the snout of the crankshaft to the balancer hub. When properly installed, the balancer hub should extend 3/32 to 11/64-inch past the crankshaft snout. If the measurement is incorrect, reinstall the balancer installation tool and press the balancer on the crankshaft until the measurement is correct. Install a new harmonic balancer bolt and tighten it to the torque and angle of rotation specifications. The remainder of installation is the reverse of removal.

Remove the old bolt and measure the distance from the snout of the crankshaft to the balancer hub. The hub should extend 3/32 to 11/64-inch past the crankshaft snout.

The remainder of the installation is the reverse of removal, meaning you should reassemble the components that were previously removed.

After battery disconnection, you need to remove the engine cooling fan and then the engine drive belt.

Remove the old bolt and measure the distance from the snout of the crankshaft to the balancer hub. The hub should extend 3/32 to 11/64-inch past the crankshaft snout.