Cadillac 26060073 Actuator,Front Drive Axle

You can Select Your Vehicle to check if 26060073 fits your vehicle.

To remove the electric shift motor/4WD actuator assembly from a vehicle's transfer case, first raise the vehicle and place it securely on jackstands. Then, remove the stone shields from below the transfer case and unplug the shift motor electrical connector. Unscrew the retaining bolts and remove the assembly. To install, inspect the seal for damage and replace if necessary. Position the gasket and 4WD actuator in place on the transfer case and install the bolts, tightening them to the specified torque. Finally, reverse the removal steps.

To remove the 4WD actuator from the axle tube, first raise the front of the vehicle and support it securely on jackstands. If equipped, remove the differential carrier splash shield. Then, disconnect the electrical connector from the 4WD actuator and unscrew the actuator from the axle tube. Before installing the actuator, coat the threads with RTV sealant and tighten it securely.

Securely raise the front of the vehicle and support it using jack stands. The splash shield is taken off. Pull out the electrical connector from the actuator. Separate actuator mounting bolts and disengage actuator from intermediate shaft housing. To fix an actuator, apply reverse removal procedure. Torque down bolts to specs as indicated above.